Applying an Oil Finish to a Walnut Bowl with Sam Angelo

In the last video, Sam turned a 13" walnut bowl (link below). Today he shows how he applied a Walnut oil finish to the bowl. This will begin a series on applying finishes to work that is still on the In the last video, Sam turned a 13" walnut bowl (link below). Today he shows how he applied a Walnut oil finish to the bowl. This will begin a series on applying finishes to work that is still on the lathe.

Turning a Walnut Bowl: https://www.youtube.com/watch?v=wiF3VzdQzfY
Link to my moisture meter-General mmd900 https://tinyurl.com/7fjy57a6

Chapter Timecodes
00:00 Introduction
02:09 Sanding approach
03:06 Moisture Meter/moisture content
05:00 Apply Seal coat of shellac
07:15 Apply the Walnut oil
07:47 Sam's comments on oil finishes
12:23 Reversing the bowl
13:15 A little wet sanding

Please Subscribe: https://www.youtube.com/channel/UCRZxyT3UUS8spkIZDAsaFnA

Thanks for watching my videos-
Please find my work on the following sites http://www.wyomingwoodturner.com
ETSY https://www.etsy.com/shop/wyomingwoodturnercom
Send me a comment or question via e-mail: @---- This email address is being protected from spambots. You need JavaScript enabled to view it.

I am now an authorized Robust lathe dealer. Please contact me if you have any questions. As a bonus for purchasing a Robust lathe through my dealership, I will provide one full day (6 hours) of instruction in my shop in Billings, Mt.

For more information on the Robust Sweet 16 wood lathe, watch my video: Sweet 16 lathe tour https://tinyurl.com/uylxh72

Scout Lathe Tour…Video from Sam Angelo https://www.youtube.com/watch?v=njFVFimn7bI&t=26s